In Stages 59-62 of our 1:8 scale Knight Rider K.I.T.T. build, we assemble and install the Passenger Seat before starting on the Left Rear Seat!
Category Archives: KITT
1:8 scale Knight Rider K.I.T.T. from Fanhome/DeAgostini
K.I.T.T. Stages 55-58
In Stages 55-58 of our 1:8 scale Knight Rider K.I.T.T. build, we finish up the Firewall and then assemble and install our Driver’s Seat. This includes adding the wonderful PMD Seat Badges from Mike Lane!
K.I.T.T. Stages 51-54
In Stages 51-54 of our 1:8 scale Knight Rider K.I.T.T. build, we focus on the lower Center Console and the Interior Floor Panel. This is also the point where we installed the Front Carpets, Heel and Toe Pads, and Floor Mats from the infamous Mike Lane!
K.I.T.T. Stages 47-50
In Stages 47-50 of our 1:8 scale Knight Rider K.I.T.T. build, we primarily work on completing the Dashboard assembly and adding the lighting LEDs. Then, we being the construction of our interior. I also install Mike Lane’s Dashboard Monitors/Power Boost mod and the Drop-In Scanner Upgrade from Brickstuff!
K.I.T.T. Stages 43-46
In Stages 43-46 of our 1:8 scale Knight Rider K.I.T.T. build, we install all of the model’s main wiring, assemble the ComLink Wristwatch, and then test all of the electronics!
K.I.T.T. Stages 39-42
In Stages 39-42 of our 1:8 scale Knight Rider K.I.T.T. build, we attach our final Wheel, install the Rear Anti-Roll Bar and Circuit Board, and then we begin the long task of wiring our model!
K.I.T.T. Stages 35-38
In Stages 35-38 of our 1:8 scale Knight Rider K.I.T.T. build, we attach our Rear Axle to the Chassis, add the Rear Suspension bits, and build the third Wheel!
K.I.T.T. Stages 31-34
In Stages 31-34 of our 1:8 scale Knight Rider K.I.T.T. build, we add the Driveshaft, some rear Fuel/Brake Lines, the entire Exhaust system, and begin to assemble the Rear Axle!
K.I.T.T. Stages 27-30
In Stages 27-30 of our 1:8 scale Knight Rider K.I.T.T. build, we do some great things. We finish up the Turbine engine and install it, as well as extend the Chassis to its full length and attach the Battery Compartment. But, I did run into problems when attaching all the hoses in Stages 28-29. Thankfully, with some persistence and research, I think we figured them all out!
K.I.T.T. Stages 23-26
In Stages 23-26 of our 1:8 scale Knight Rider K.I.T.T. build, we complete the Air Intake system of our Turbine engine!